Important Uk Wiring Instructions; Operation - Waring NuBlend BB180PK Operating Manual

This appliance is supplied with a fitted plug; however, for your information,
should you wish to change the plug, the wires in the mains lead of the
appliance are colored in accordance with the following code:
Warning: The severed plug should be disposed of to avoid a possible
shock hazard and should never be inserted into a 3A socket. As the
colors of the mains lead of this appliance may not correspond to the
colored markings identifying the terminals in your plug, proceed as
follows: the wire which is colored Green & Yellow must be connected to
the terminal in the plug which is marked with the letter E or by the earth
symbol or colored Green or Green & Yellow. The wire which is colored
Blue must be connected to the terminal which is marked with the letter
N or colored Black or Blue. The wire which is colored brown must be
connected to the terminal which is marked with the letter L, or colored
Red or Brown.
NOTE: If the terminals of the plug are unmarked or if you are in any doubt,
consult a qualified electrician. If a BS363 Fused Plug is used, this must
be fitted with the correct amperage fuse – 3A. This applies to UK models
only.
. Put ingredients into container and cover it. Always add liquid ingredients
first, unless otherwise specified in recipe. Do not fill above MAX line.
Plug the blender cord into outlet.
2. With the toggle switch in "OFF" O position, place container on blender. Be
sure container is fully seated and that drive coupling is properly engaged.
3. This blender has 2 speed settings: "HI" and "LO"
desired
position. To crush ice, use "HI"
4. This blender is equipped with a
engage Pulse
is released.
5. When finished processing, set toggle switch to "OFF" O position.
6. Allow motor to come to a complete stop before removing container from
blender.
7. Note: Containers with removable bottoms have right-handed threads.
When reassembling, be sure rubber seal is positioned between the
container and the flange on the blade assembly.

IMPORTANT UK WIRING INSTRUCTIONS

Green and Yellow:
Blue:
Brown:
function. Unit will run on HI speed until the toggle switch
Earth
Neutral
Live

OPERATION

II
speed setting.
option. Hold toggle in down position to
2
I
. Switch toggle to