Table of Contents
Advertisement
7. Allow motor to come to a complete stop before removing container from
blender base. Never place the container on the motor base or remove it
from the motor base while motor is running.
8. Always hold container with one hand when starting and while blending.
Never operate without jar lid.
9. Wash and dry container after each use. See Cleaning and Sanitizing
instructions.
To minimize the possibility of being scalded when blending hot materials,
the following precautions and procedure must be observed.
• Hot materials are those that are 100°F (38°C) or hotter.
• Limit the amount of materials processed to 1 pint.
• Completely remove the center portion of the two-piece container lid before
starting motor (this will allow venting of the rapidly heated and expanding
air inside the container when blender is running).
• Always start blending on lowest speed setting, and then progress to
desired speed.
• Never stand directly over blender when it is being started or while it
is running.
CLEANING AND SANITIZING INSTRUCTIONS
THE CONTAINER MUST BE CLEANED AND DRIED AFTER EACH USE
OF THE BLENDER ACCORDING TO THE FOLLOWING INSTRUCTIONS.
FAILURE TO DO SO MAY ALLOW RESIDUES OF PROCESSED MATERIAL
TO COLLECT ON THE INTERNAL SEALS OF THE BLADE ASSEMBLY,
RENDERING THEM INEFFECTIVE.
• Wash, rinse, sanitize and dry container prior to initial use and whenever
it will not be used again within a period of 1 hour.
• Wash and rinse container after each use.
• Clean and sanitize motor base prior to initial use and after each use.
• Washing solutions based on non-sudsing detergents and chlorine-based
sanitizing solutions having a minimum chlorine concentration of 100 PPM
are recommended.
The following washing, rinsing, and sanitizing solutions, or their equivalents,
may be used.
SOLUTION
Washing
*Diversol
Rinsing
Sanitizing
*Diversol
is a registered trademark owned by the Diversey Wyandotte Corp.
®
**Clorox
is a registered trademark owned by the Clorox Company.
®
HOT BLENDING INSTRUCTIONS
PRODUCT
Diversy Wyandotte
BX/a or CX/A
®
Plain Water
**Clorox
®
Institutional Bleach
IMPORTANT
DILUTION IN WATER
4 Tablespoons
/Gallon
1 Tablespoon/Gallon
TEMPERATURE
Hot 115˚F ( 46˚C )
Warm 95˚F (35˚C)
Cold 50-70˚F
( 10-21˚C)
Advertisement
Table of Contents
