Battery Cable Fusing; Hardware Stack-Up Options - Xantrex Freedom Marine Series Owner's Manual

INSTALLATION

Battery Cable Fusing

A fuse is required by the NEC to protect
the battery and cables. A UL Listed DC rated
slow blow fuse must be installed in the positive
(+) battery cable, within 72 inches of the
battery or within 7 inches of a positive bus or
switch.
Recommended Fuse: UL Listed Class T
JLLN with a DC Rating. This fuse with fuse
holder is available from your dealer or Xantrex.

HARDWARE STACK-UP OPTIONS

COMPRESSION / RING TERMINAL
INVERTER
CABLE
WARNING
Improper stack up of hardware will cause
excessive heat and fuse failure. Stack up
as shown.
28
+ (red)
EXPLODED VIEWS
OF FUSE ASSEMBLY
NUT
LOCK WASHER
FLAT WASHER
BATTERY
CABLE
FUSE
FUSE HOLDER
For Freedom 10 & 15
200 amp Fuse & Holder PN# 84-4155-00 (C/R)*
200 amp Fuse & Holder PN# 84-4158-00 (R/R)**
200 amp Fuse Only
For Freedom 20, 25, & 30
300 amp Fuse & Holder PN# 84-4156-00 (C/R)*
300 amp Fuse & Holder PN# 84-4154-00 (R/R)**
300 amp Fuse Only
* Compression / Ring Terminal
** Ring / Ring Terminal
RING / RING TERMINAL
INVERTER
CABLE
PN# 84-4157-00
PN# 84-4151-00
NUT
LOCK WASHER
FLAT WASHER
BATTERY
CABLE
FUSE
FUSE HOLDER