In Water Inspection - Hunter Marine Family User Manual

Dockside inspection of Engine, Pre-start sequence and operating system
____ Review engine manual for maintenance requirements and proper starting procedure
____ Propeller shaft properly aligned (per engine manual)
____ Shaft to engine coupling bolted and properly torque (per engine manual)
____ All engine mounting bolts in place and properly torque (per engine manual)
____ Crankcase oil at full mark (per engine manual)
____ Transmission fluid / oil at full mark (per engine manual)
____ Coolant mix ratio proper – heat exchanger and expansion tanks full (per engine
manual)
____ Seawater intake valve open and no leaks
____ Air bled from fuel lines and system
____ No fuel leaks at any fittings
____ Throttle linkages smooth and operational
____ Shutdown system operational
____ USCG Oil Discharge warning poster in place
____ Exhaust elbows and hoses tight
____ Starting sequence and alarms correct
____ Oil pressure acceptable (per engine manual)
____ Coolant temperature acceptable (per engine manual)
____ Alternator DC output at rated rpm (per engine manual)
____ Correct Idle rpm (per engine manual)
____ Water discharged with exhaust
____ Hour meter operational
____ Fuel level indicators operational
____ Throttle cable tension set properly
____ Shifter operation correct
____ Neutral safety start switch operational
____ No inboard exhaust gas leaks
____ No fuel / oil / water leaks on engine
____ Shaft packing / Drip free Seal adjusted and locknuts tight. One to three drips per minute with
shaft turning on traditional packing assembly
____ Engine box installed and secured
____ Review and follow manufacturer's manual for maintenance and up-keep
____ Seawater strainer water-tight and clean
____ No leaks in fuel system - Fuel filters clean
____ Lube oil at full mark
____ Coolant level full – proper mix ratio with water (per generator manual)
____ Seawater discharge overboard with exhaust gas
____ No inboard water or exhaust gas leaks
____ Proper voltage output to distribution panel (per generator manual)
____ Ship / Shore power transfer panel function properly
____ Starter battery box secured
____ Starter battery cable connections clean and tight
____ Starting battery electrolyte level proper

In Water Inspection

Dockside inspection of Generator,
Pre-start sequence and operating system
PAGE 11A- 7