Hunter Marine Family User Manual page 22

____ Vent clear from tank to atmosphere
____ Filled with fresh water and test pumped with macerator
____ Toilets flush to holding tanks properly
____ Waste level indicating system properly functioning
____ No leaks at any hose fitting within the system
____ Gas bottle filled installed and connected to regulator. Inspect Gas system for leaks after 3
minutes. Should a leak be detected immediately close the main valve exit boat and seek
professional assistance for a thorough inspection.
____ Stove and oven operational. Refer to manufacturer's manual for proper operation and
trouble shooting.
____ Gimbal latch secure and operational
____ LPG stowage locker drain open and tank storage area free of derbies.
____ Microwave operational
____ Refrigerator operational and proper temperature attained
____ Freezer operational and proper temperature attained
____ USCG waste disposal-warning poster onboard or in owner's package
____ Icebox drains to sump or bilge properly
____ Icebox drain plugs installed
____ Swim seats / ladders / gates operational
____ Swim seat latch operating correctly
____ Cockpit hatches operate properly (adjustments should be made with boat in water)
____ Canvas properly cleaned and installed
____ Cockpit cushions cleaned and installed
____ Lifeline fittings tight and secure
____ Rubrail sealed secured to hull
____ Sliding hatches drains free of debris
____ Companionway drop-ins fit properly in companionway and stowage rack
____ Load bearing hardware sealed and securely fastened. This includes but is not limited to
chainplates, winches and handrails
____ Traveler arch sealed and securely fastened. Stainless Steel models should be properly
grounded, see owners manual for details
____ Plexiglas hatches, ports, windscreens and windows adjusted and cleaned. Cleaners and
polishers specifically for Plexiglas can be purchased from most marine supply stores
____ External teak cleaned and oiled (Teak decking cleaned with mild soap and water)
____ External railings cleaned with soap and water then hand polished using automotive wax
____ All deck fill caps seal properly and have retainer chains intact (except Waste Pump-out)
____ Dorade vents or sealing caps installed
____ Topside surface clean and free of gelcoat damage
Head and Holding Tank Systems
Galley Systems
Topside Inspection
PAGE 11A- 5