GE Monogram ZIS42N Custom Options Manual And Installation Instructions page 47

The use of this custom collar trim requires that the hole
Cut dispenser
hole and rout
for dispenser be located and cut very accurately . 3/4"
door panel
door panels must be routed on all 4 sides of the
dispenser cutout.
Rout the back side of the panel 1/4" deep and 7/8" wide,
flush with the edge of the cutout.
Install
collar
brackets
and trim
Select the door panel size for your application.
• If using the standard 1⁄4" trim, follow the installation
• When using another optional trim kit, use the
• Remove the aluminum trim above and below the
• Remove and discard the standard full-width
• Remove 2 screws above and below the dispenser
Note:
require routing.
instructions packed with the product.
instructions provided with that kit to install the panel
trim and/or custom handles.
dispenser. Discard trim.
dispenser trim.
recess. Retain screws.
ZWCD1 Trim Kit
1/4" door panels do not
• Secure top and bottom brackets to the dispenser,
using the screws previously removed.
• Install the custom panels according to the appropriate
installation instructions.
• Select the black or white collar trim according to
appearance desired.
• Match the indentations on the collar trim to the tabs
on the lower bracket. Push the collar flush against
the door.
• Drive 2 screws (provided) upwards through the collar
and into the brackets.
Custom Dispenser Collar
9 7/16"
7/8"
Wide
12 5/16"
Rout
The Cutout is 9 7/16" wide
by 12 5/16" high. 3/4" panels
must be routed on all four
sides of the cutout. Rout
the back side of the panel
1/4" deep. 7/8" wide.
47