GE Monogram ZIS42N Custom Options Manual And Installation Instructions page 40

Step 2A: If you are installing these handles onto Stainless Steel
panels:
Use extreme caution if you are drilling through
stainless steel panels. Stainless panels must be
FOR
handled gently. Do not kneel on stainless steel panels.
STAINLESS
It will leave a permanent dent. Do not remove protec-
STEEL
tive plastic covering until final installation.
PANELS
• Place supplied filler panel (corrugated) on floor to use
• On the back side of the panel–at the handle side,
For models with full width dispenser trim and 2-piece
freezer panels:
– Measure and mark 1/4" below the top edge of the
– Measure and mark 1/4" above bottom edge of lower
• Slip panels into the new extrusion, flush against inner
• Place a handle standoff on each attachment post
Step 3:
along the handle. Position the set screw hole on each
Install
Standoffs standoff to point to the floor.
onto Handles
• Install set screws into the bottom of each standoff,
using the Allen wrench provided. The standoff should
be tight against the handle.
Step 4:
Install
Handles
and
Panels
FOR CUSTOM
WOOD
PANELS
See Step 4A
for Stainless
Steel panels
• Press foam pads against steel doors to temporarily
• Slide panels into the door trim. Leave about 4" of the
• Place extrusion onto back side of panel, install
40
as a pad.
measure and mark 1/4" below the top edge of the
panel.
upper panel.
panel.
edge, on the handle side.
reduce thickness.
panel exposed to allow room to install the handle
extrusion.
mounting screws through the extrusion and the
custom panel.
ZKHSS1 for 1/4" Panels
Tubular Stainless Steel Handles
• Align extrusion to pencil mark(s) as shown in Step 2.
Mark each screw hole location with pencil.
• Tape extrusions to panels to prevent movement.
• Place panel on plywood section, appearance side
down. Be sure plywood is clean without nicks and
burrs. Center punch at each screw hole location.
• Drill 1/8" pilot hole. Use 9/32" bit to enlarge clearance
hole.
• Measure and cut a 2" wide strip, top to bottom off the
corrugated panels. This will allow room for spacer
rings between the stainless panel and extrusion.
Door
Handle
• Screw handle to panel, starting at the top. Moving
down the handle, drive each screw partially into the
standoff, alternating back to the top until the handle is
tight against the panel.
• Slide the assembly into the door frame until the
extrusion fits firmly against the steel door.
• Reinstall original screws into the door extrusion.
Screw
Allen Wrench
Screw
Decorator
Door Panel
Handle