GE Monogram ZIS42N Custom Options Manual And Installation Instructions page 24

• Open door to 90 . Remove the screws from the
OPTION 2
For dispenser model
using full-width
• Retain screws, discard handle.
trim
Step 1
Remove handles
Step 2
Remove door panel trim above and below dispenser.
Remove trim
Lift off dispenser trim. Retain screws and trim.
• Position the handle bracket onto the steel door by
Step 3
Locate
position
of handle
• Re-install dispenser trim, temporarily.
• Determine the desired location of the custom handle
• Drill 1/16" pilot hole
• Remove dispenser trim
24
full-length aluminum handle of the freezer door.
matching existing screw holes on the door and
bracket. Temporary secure with screws.
and carefully mark centerlines of the screw holes.
through the trim until it
starts into the handle
bracket. This will mark
the matching location for
drilling a clearance hole
when assembling the
handle, bracket and
dispenser trim.
and bracket.
ZKH1 Trim Kit (For 1/4" Panels)
Support for Custom Handles
Temporarily
Secure
Handle
Bracket
With
Screws
Remove
Trim
Remove
Dispenser Trim
Temporarily
Secure
Dispenser
Trim
With
Screws