GE Monogram ZIS42N Custom Options Manual And Installation Instructions page 25

Option 2 Installation
Step 4 • Drill clearance holes through the handle bracket and
Install
custom handle
• Install screw(s) long enough to pass through the
• Mount assembled dispenser trim with handle onto
Step 5
Mount
assembled
• Drive 2 screws through the top and bottom of the
dispenser trim
• Re-install 3 screws at top and bottom of
Step 6 • Slide decorator panels into the trim, top and bottom.
Install
• Slide freezer door extrusion in between panels and
custom handle
extrusion
• To install fresh food handle follow the same procedure
the dispenser trim.
handle bracket, dispenser trim and into the
custom handle.
Note:
be installed against the handle
bracket. The custom handle
cannot exceed 11-3/4" length.
the door.
handle bracket into the steel door.
dispenser trim.
Important:
bracket must be secured to the
steel door. If it is not secured
properly, the dispenser trim will
pull away from the door.
steel door. Secure with screws.
as shown in Option 1.
ZKH1 Trim Kit (For 1/4" Panels)
Handle Bracket
The custom handle must
Secure
Assembled
Dispenser
The handle
Trim
With
Screws
Support for Custom Handles
Dispenser Trim
Handle Bracket
Dispenser Trim
Custom Handle
Freezer
Handle Side
Extrusion
Secure
Handle
Bracket
With
Screws
25