Preparing The Remote Controller - Onkyo L-MS30 Instruction Manual

EN00_L-MS30.book Page 9 Tuesday, September 2, 2003 4:19 PM

Preparing the Remote Controller

Inserting the Batteries
1
Detach the battery cover.
2
Insert the two size AAA/R03 batteries.
Be sure to match the + and – ends of the batteries with the
diagram inside the battery compartment.
3
Attach the battery cover.
Notes
• Do not mix new batteries with old batteries or different kinds of
batteries.
• To avoid corrosion, remove the batteries if the remote controller is
not to be used for a long time.
• Remove dead batteries immediately to avoid damage from
corrosion. If the remote controller does not operate smoothly,
replace both batteries at the same time.
• The life of the batteries supplied is about six months but this varies
depending on usage.
Pointing the remote controller in the
right direction
Point the remote controller toward the remote control sensor.
Remote control sensor
Notes
• Place the unit away from strong light such as direct sunlight or
inverted fluorescent light which can prevent proper operation of the
remote controller.
• Using another remote controller of the same type in the same room
or using the unit near equipment which uses infrared rays may
cause operational interference.
• Do not put any object such as a book on the remote controller. The
buttons of the remote controller may be pressed by mistake and
drain the batteries.
• Make sure the audio rack doors do not have colored glass. Placing
the unit behind such doors may prevent proper remote controller
operation.
• If there is any obstacle between the remote controller and the
remote control sensor, the remote controller will not operate.
9