Adjusting The Sound; Music Mode - Onkyo L-MS30 Instruction Manual

Dvd theater system

Hide thumbs Also See for L-MS30:

Brochure & specs (2 pages)

Table Of Contents

Table of Contents

EN00_L-MS30.book Page 46 Tuesday, September 2, 2003 4:19 PM

Enjoying the Sound Effects

SURROUND

A.CONTROL

Selecting Surround Mode

Press SURROUND.

Main unit

Each press switches the modes as shown below.

(At the time of PCM source or Dolby Digital 2ch source)

DOLBY PL II MOVIE

DOLBY PL II MUSIC

STEREO

(At the time of Dolby Digital 5.1ch source)

Dolby Digital

STEREO

(At the time of DTS source)

DTS

STEREO

When playing a source encoded in Dolby Digital or DTS, the

surround mode is set to "Dolby Digital/DTS" automatically.

Note

Don't change the listening mode while recording with a VCR.

Tip

The Input/Speaker indicator becomes an input indicator at time of

DOLBY DIGITAL and DTS source and a speaker indicator at all

other times.

Description of Dolby Pro Logic II:

Music mode

Panorama mode

Expands the image of front-channel stereo to the surround speakers

to create a sound environment that fills your surroundings. (To

change the Panorama mode, press SETUP button at the time of

Dolby Pro Logic II Music mode. Display the PANO R OFF or ON,

then press the LEVEL +/– buttons to select ON or OFF.)

Remote controller

Dimension

This controls the balance between the Front and Rear in 2 steps on

the front and 2 steps on the rear. Set this parameter to one of the

Front steps if the surround effect is too strong, or to one of the Back

steps if it is too weak. (To change the Dimension, press SETUP

button twice at the time of Dolby Pro Logic II Music mode. Display

the DIMEN 0 (or other value), then press the LEVEL +/– buttons to

select F-2, F-3, R-2 or R-3.)

Center Width

The center channel signal can be divided and distributed to the Front

L/R channels.

The adjustment for distributing the center channel signal to the front

channels can be applied in eight steps from 0 to 7. Use this

adjustment when the center image seems to be too strong. (To change

the Center Width, press SETUP button 3 times at the time of Dolby

Pro Logic II Music mode. Display the C WIDTH 3 (or other value),

then press the LEVEL +/– buttons to select 0 ~ 7

Checking the Sound System of the

Playing Source

The DVD receiver will automatically detect the sound system when

DOLBY DIGITAL Surround (

PCM/MP3 DIGITAL (2 channel digital stereo) is played back. The

corresponding sound system indicator lights in the DVD receiver's

display.

DISC

Surround

mode

Dolby

Digital

5.1ch

2ch

Dolby Digital

DTS

PL II

STEREO