Preparing The Remote Controller; Inserting The Batteries - Onkyo HTC-V10X Instruction Manual

HTC-V10X_En.book Page 11 Wednesday, July 21, 2004 2:49 PM

Preparing the Remote Controller

■ Inserting the batteries

1
1 Detach the battery cover.
2 Insert two size-AA/R6 batteries.
Be sure to match the + and – ends of the batteries with to diagram inside the battery
compartment.
3 Attach the battery cover.
• Do not mix new batteries with old batteries or different kinds of batteries.
• To avoid corrosion, remove the batteries if you do not intend to use the remote controller
for a long time.
■ Using the remote controller
Remote control
sensor
Point the remote controller toward the PR-155X's remote control sensor.
• Place the unit away from strong light, such as direct sunlight or inverted fluorescent light,
which can prevent proper operation of the remote controller.
• Using another remote controller of the same type in the same room or using the unit near
equipment that uses infrared rays may cause operational interference.
• Do not put any object (such as a book) on the remote controller. The buttons of the remote
controller may be pressed by mistake, which drains the batteries.
• Make sure the audio rack doors do not have colored glass. Placing the unit behind such
doors may prevent proper remote controller operation.
• If there is an obstacle between the remote controller and the remote control sensor, the
remote controller will not operate.
2
PR-155X
3
11