Abit PR5 User Manual page 70

PCI PnP BIOS Auto-Config
PCI IRQ Actived By
1st Available IRQ
2nd Available IRQ
3rd Available IRQ
4th Available IRQ
PCI IDE Card 2nd Channel
PCI IDE Card IRQ Map to
-Primary IDE INT#
-Secondary IDE INT#
PS/2 Mouse Function(IRQ12): Enable
Onboard IDE-1 Controller
-Master Drive PIO Mode
-Slave Drive PIO Mode
Onboard IDE-2 Controller
-Master Drive PIO Mode
-Slave Drive PIO Mode
Award BIOS PCI & Onboard I/O Setup
PCI & Onboard I/O Setup
To enter this section of the Setup program, highlight this
menu item in the main menu and press the Enter key.
The following screen will appear.
ROM PCI/ISA BIOS(XXXXXXXX)
PCI & ONBOARD I/O SETUP
AWARD SOFTWARE INC.
Onboard FDD Controller
: Disable
Onboard Serial Port 1
: Level
Onboard Serial Port 2
: 9
-Onboard IR Function
: 11
-IR Duplex Mode
: 10
-IR Tr/Re Polarity
: 5
Onboard Parallel Port
-Parallel Port Mode
: Enabled
-ECP Mode Use DMA
: PCI-AUTO
: A
: B
: Enable
: AUTO
ESC : Quit
: AUTO
F1
: Enable
: AUTO F5
: AUTO
F6
F7
Menu Commands
The menu commands for this screen are the same as for
the BIOS Features Setup screen.
PCI PnP BIOS Auto-Config
This function will automatically assign IRQs to PCI ex-
pansion slot INT#s as needed when enabled. If disabled,
IRQs are assigned via the Available IRQ settings that fol-
low after the next item. The default setting is Disabled.
PCI IRQ Actived By
The Level setting is required, don' t change it.
Available IRQ
These four lines allow setting which IRQs will be assigned
as needed to PCI expansion slot INT#s. The sequence
controls the order in which the IRQs are assigned. The
system looks at the PCI slots in the order Slot 1, 2, 3. The
IRQ options are 3, 4, 5, 7, 9, 10, 11, 12, 14 and 15.
: Enable
: 3F8/IRQ4
: 2F8/IRQ3
: HPSIR
: Half
: Hi/Hi
: 378/IRQ7
: ECP/EPP1.9
: 3
:Select Item
: Help PU/PD/+/-
: Old Values (SHIFT)F2
: Load BIOS Defaults
: Load Setup Defaults
: Modify
: Color