Related Manuals for ELECTROCOMPANIET PI-2
Summary of Contents for ELECTROCOMPANIET PI-2
- Page 1 PI-2...
- Page 2 Illustration 1 – Back panel Illustration 2 – Front panel...
- Page 3 1 pcs inspection card. Set up procedure Before connecting the PI-2 to the mains, check that the main voltage indicated on the rear panel corresponds to the line voltage in the territory where you intend to use the unit. How to avoid damages Do not under any circumstances connect or disconnect equipment when power is turned on.
- Page 4 Connect the red connector to the plus side on the speakers and the white connector to the minus side on the speakers. Never short the positive output to ground or chassis. Always switch the PI-2 off when you connect the speakers. Front panel See illustration 2.
- Page 5 Internal fault. Please contact service. ERR TMP The PI-2 has overheated. This is caused by either playing to loud for a long period of time or not enough free space on the sides or above the PI-2. Turn down the volume and make sure there is enough free space around the PI-2.
- Page 6 Technical specifications PI-2 The following technical data were measured on randomized test objects and are typical data. All measurements are made at 120V / 240V // 50Hz / 60Hz Measurements Input impedance 47 kOhm Output impedance 0,03 Ohm Noise floor (0 dB gain) <...
- Page 7 Important Notice For optimal sonic performance, the PI-2 should be burned in for a minimum time of 72 hours. If the PI-2 has been switched off, allow two hours of warm-up for optimal sonic performance. Proper ventilation is important. Never cover the ventilation area.