Table of Contents
Advertisement
User Manual PXA125
Figure 3-47. An Example of Generating Sine Waveforms From the Built-in Library.
Creating Sine Waveforms
Use the following procedure to create sine waveforms from the built-in
library. Click on Wave, then sine... the dialog box as shown in Figure
3-17 will appear. You can now start programming parameters that are
available in this box.
Start Point – Defines the first point where the created wave will start.
Note that if you change the start point the left anchor will
automatically adjust itself to the selected start point. The example
shows start point set at point 0.
End Point – Defines where the created waveform will end. Note that
as you change the end point the right anchor will automatically adjust
itself to the selected end point. The example shows end point set at
3-80 ArbConnection
Advertisement
Table of Contents
