Table of Contents
Advertisement
User Manual PXA125
<time>
1e-3 to 1000 in units of seconds
SWEep:TIME?
Response and default
The PXA125 will return the present sweep time value. The returned value will be in standard scientific format
(for example: 10ms would be returned as 10E-3 – positive numbers are unsigned). Default value is 1e-3.
SWEep:DIRection{UP|DOWN}
Purpose
This command will select the sweep direction up and down.
<UP> selects an up direction. The sample clock will sweep from start frequency set by the sclk parameter
to stop frequency set by the stop sclk parameter
<DOWN> selects the down direction. The sample clock will sweep from stop frequency set by the stop
sclk parameter to start frequency set by the sclk parameter
Parameter type
Discrete
SWEep:DIRection?
Response and default
The PXA125 will return UP, or DOWN depending on the present PXA125 setting. Default value is UP.
SWEep:SPACing{LINear|LOGarithmic}
Purpose
This command will select the sweep spacing from linear spacing and logarithmic spacing.
<LINear> will select linear steps
<LOGarithmic> will select logarithmic steps
Parameter type
Discrete
SWEep:SPACing?
Response and default
The PXA125 will return LIN, or LOG depending on the present PXA125 setting. Default value is LIN.
SWEep:TRIGger:MODE{CONTinuous|TRIGered|GATEd}
Purpose
This command will select one of the sweep modes.
CONTinuous will select continuous sweep modulation
TRIGered will select triggered sweep modulation
GATEd will select gated sweep modulation
Parameter type
Discrete
SWEep:TRIGger:MODE?
Programming Reference 4-47
Advertisement
Table of Contents
