Remote Oil Filter (Optional) - Westerbeke 12C- TWO Operator's Manual

REMOTE OIL FILTER (OPTIONAL)
. PN# 040078 .
INSTALLATION
This
popular accessory ·is used to
reloc~te
the engine's oil fil-
ter from the engine to a more convenient location such as an
engine room bulkhead. .
NOTE: Refer to ENGINE OIL CHANGE in this manual for
instructions on removing the oil jilter.
To install, simply remove the engine oil filter and thread on
WESTERBEKE's remote oil filter kit as shown. Always
install this kit with the oil filter facing down as illustrated.
Contact your WESTERBEKE dealer for more infonnation.
APPLY A THIN COAT OF CLEAN OIL TO THE O·RING WHEN
INSTALLING THIS KIT. THREAD THE KIT ON, THEN HAND
TIGHTEN AN ADDITIONAL 3/4 TURN AFTER THE O·RING
CONTACTS THE BASE.
NOTE: Westerbeke is not responsiblefor engine failure due to
incorrect installation of the Remote ail Filter. . ,
A
CAUTION:
It Is vital to install the
oillin~s
correctly.
If
the oil flows in the reverse direction, the
bY1lass. valve In the filter assembly Will prevent the oil
from reaching the engine causing an internal engine
failure.
'If
there is no oil pressure reading, shutdown
imediatelyand check the hose cnnnections.
FASTEN SECURELY,IO A
B~~:~IT:~1
(SCREWS ARE OWNER
iii
THE IN CONNECTION HOSE
MUST ATTACH TO THE OUT
THE OUT CONNECTION
MUST ATTACH TO THE
CONNECTION ATTHE
REMOTE OIL FILTER.
~
_ _
iiCiO~MNNioEii'ECTI.DiOiN
AT THE
'" FILTER.
, Engines & Generators
21
" APPLY, A THIN COAT OF CLEAN OIL TO niE FILTER
, GASKET WHEN INSTALLING. AFTER THE FILTER
, toNTACTS THE BASE, TIGHTEN IT AN ADDITIONAL