Using Usb Legacy Support - HP EliteBook User Manual

CAUTION:
To stop and remove a USB device:
1. Double-click the Safely Remove Hardware icon in the notification area, at the far right of the
taskbar.
NOTE:
<<) in the notification area.
2. Click the name of the device in the list.
NOTE:
3. Click Stop, and then click OK.
4. Remove the device.

Using USB legacy support

USB legacy support (enabled at the factory) permits the following actions:
● Using a USB keyboard, mouse, or hub connected to a USB port on the computer during startup or
in an MS-DOS-based program or utility
●
Starting or restarting from an optional external MultiBay or an optional USB bootable device
To disable or reenable USB legacy support in Computer Setup, follow these steps:
1. Turn on or restart the computer, and then press
message is displayed at the bottom of the screen.
2. Press f10
3. Use a pointing device or the arrow keys to select System Configuration, and then select Device
Configurations.
4. To disable USB legacy support, click Disabled next to USB legacy support. To reenable USB
legacy support, click Enabled next to USB legacy support.
5. To save your changes and exit Computer Setup, click Save in the lower-left corner of the screen,
and then follow the on-screen instructions.
– or –
Use the arrow keys to select File > Save changes and exit, and then follow the on-screen
instructions.
Your changes go into effect when the computer restarts.
98 Chapter 7 External devices
To prevent damage to a USB connector, do not pull on the cable to remove the USB device.
To display the Safely Remove Hardware icon, click the Show Hidden Icons icon (< or
If the USB device is not listed, you do not have to stop the device before you remove it.
to enter the BIOS Setup.
esc while the "Press the ESC key for Startup Menu"