Adjusting The Fusing Temperature Manually - Ricoh 7700W Operating Instructions Manual

Copy Settings
B
When the wait indicator goes off and the ready and the set original indica-
tor go on, the copier enters the ready condition.
Note
Even if you select the media type correctly, creasing might occur depend-
ing on the temperature or humidity. If this happens, adjust the fusing tem-
perature manually. See the next page.

Adjusting the Fusing Temperature Manually

3 A
Press the { { { { Copy Media} } } } key to turn on the Translucent or Film indicator that
you want.
B
Hold down the { { { { Copy Media} } } } key for 3 seconds until beep. The indicator
show the current fusing temperature. The unlit indicator shows the current
temperature settings.
C
Press the { { { { i
increase the temperature. The number of temperature levels (7 levels) avail-
able depends on the paper type:
• Plain paper : 1234567
• Translucent paper: 1234
• Film : 1234
D
After you have finished setting the temperature, press the { { { { Copy Media} } } } key.
28
i } } } } key to decrease the temperature, and press the { { { { j
i i
j } } } } key to
j j