When Memory Is Full - Ricoh 8016 Copy Reference Manual

Troubleshooting
❖ ❖ ❖ ❖ Duplex (Type 3 only)
Problem
Order of copies is not cor-
rect.
In Duplex Margin mode,
parts of the original image
3
are not copied.
When using Duplex, copy
is made Top to Top even
though Top to Bottom is se-
lected.

When Memory Is Full

Messages
Memory is full. [Print] scanned
orig., [Clear] to cancel/clear
memory.
[Clear][Print]
Note
❒ Copying will stop and this message will be
displayed when the memory is full.
Reset * orig., then press [Re-
sume] to scan and copy the re-
maining originals.
[Stop] [Resume]
42
Causes
You set originals in the in-
correct order.
The margin is too wide.
You placed the originals in
the wrong orientation.
Causes
The scanned original
exceeds the number
of pages that can be
stored in memory.
The machine checks
if the remaining orig-
inals should be cop-
ied, after the scanned
original has been
printed.
Solutions
When setting a stack of originals in
the ADF or ARDF, the last page
should be on the bottom.
If you set an original on the expo-
sure glass, start with the first page
to be copied.
Set a narrower margin with the user
tools. See "Duplex Margin" in p.55
"Duplex Margin".
Place the originals in the correct ori-
entation. See p.18 "Original Orien-
tation" .
Solutions
Press [Print] to copy
scanned originals
and cancel the scan-
ning data. Press
[Clear] to cancel the
scanning data and
not copy.
To continue copying,
remove all copies,
and then press [Re-
sume]. To stop copy-
ing, press [Stop].