Emerson 375 User Manual page 91

Troubleshooting
HART Error and Help Messages
"Poll Using Long Tag" allows the user to enter the
long tag of the device they want to connect to.
"Poll Using Tag" allows you to enter the tag of the
device you want to connect to.
Enter Device Long Tag.
Enter the long tag that corresponds to the device
you want to connect to.
Hart Application Error... "hc.ddl device revision x
not found."...Refresh System Card...See User's
Manual and Programming Interface for details.
Hart Application Error... "registry failure"...Reinstall
System Files...See User's Manual for details.
Voltage is currently detected at the Fieldbus
Terminals. Reconfigure unit and try again.
CDC Error..."failure while switching to
HART"...Reinstall System Files...See User's
Manual for details.
DD Error..."tokenizer mismatch"...DD version
<manufacture name, device name, dev. rev. #, and
DD rev. #>; HART application <version x.y>; HART
app version x.y...Reinstall DD...See Programming
Interface for details.
DD Error..."linker mismatch"...DD version x.y;
HART app version x.y...Reinstall DD...See
Programming Interface for details.
DD Error..."developed-to mismatch"...DD version
<manufacture name, device name, dev. rev. #, and
DD rev. #>; HART application <version x.y> ...See
Programming Interface for solution.
Warning: this DD is untested with the current Hart
App ver <manufacture name, device name, dev.
rev. #, and
DD rev. #>...you may experience unexpected or
inappropriate results...See Programming Interface
for details on DD updates...Do you want to accept
these risks and proceed?
DD Error..."tested-to sequence mismatch"...DD
version <manufacture name, device name, dev.
rev. #, and
DD rev. #>; HART application <version x.y>; HART
app version x.y...See Programming Interface for
solution.
DD Error..."developed-to mismatch"...DD version
<manufacture name, device name, dev. rev. #, and
DD rev. #>; HART application <version x.y>; HART
app version x.y...Reinstall DD...See Programming
Interface for details
Description
This is a help message.
This is a help message.
This is a help message.
This is a help message.
This error message appears when an
expected version of hc.ddl is not found.
This error message appears when the
information describing the location of the
DD's is not found in the registry.
This error message appears when the HART
app found voltage on the FF connector
during initialization and during reconnection
to a device.
This error message appears when the HART
app fails to put the CDC in HART mode for
talking to a HART device.
This error message appears when the
version of the tokenizer used to tokenize the
DD is not what the HART app expects.
This error message appears when the
version of the linker used to link the DD is not
what the HART app expects.
This error message appears when the DD
was developed and tested using a later
HART app revision.
This warning message appears when the DD
was not tested and verified with the HART
app.
This error message appears when the DD
was tested with a previous version but not
with this version of the HART app.
This error message appears when the DD
was developed using a later HART app
revision.
5-7