Dmx Personality; Dmx Control; Loss Of Signal Setting; Static Mode - Chauvet COLORado User Manual

Operation

DMX Personality

DMX Control

Loss of Signal Setting

Static Mode

-10-
This setting allows you to choose a particular DMX personality.
1. Go to the PERS main level.
2. Select the desired personality (TOUR, TR16., ARC.1, AR1.d, AR1.S, HSV.).
· See the DMX Values section for the highest starting address you can select for
each personality.
· Make sure that the starting addresses on the various products do not overlap
due to the new personality setting.
In this mode, each product will respond to a unique starting address from the DMX
controller. All products with the same starting address will respond in unison.
1. Select a DMX personality as shown in
2. Set the running mode:
a. Go to the RUN main level.
b. Select the dMX. programming level.
3. Set the starting address:
a. Go to dMX main level.
b. Select the starting address d.(001~512).
The highest recommended starting address for each DMX mode is as follows:
DMX DMX
Mode Address
TOUR 504
TR16. 500
This setting controls how the product will respond when the DMX signal is lost.
1. Go to the SET main level, and select DERR.
a. Select SAVE. to make the product use the last command used when the
signal is lost.
b. Select BLAK. to turn off the all the LEDs when the signal is lost.
The Static mode allows the mixing of RGB colors and the setting of the strobe frequency
without a DMX controller.
1. Go to the STAT main level.
2. Select the desired color: R. (red), G. (green), b. (blue).
3. Select the desired color value (000~255).
4. Repeat for the other colors.
5. Select ST. (strobe frequency).
6. Select the desired strobe frequency 00~20 (0~20 Hz).
DMX Personality.
DMX DMX
Mode Address
ARC.1 510
AR1.d 509
COLORado™ 1-TRI TOUR User Manual
DMX DMX
Mode Address
AR1.S 508
HSV 510