A&D HR-250AZ Instruction Manual page 36

5 Confirm that there is nothing on the pan and press the
PRINT key. The balance measures the zero point and
displays the measured value. Do not allow vibration or
drafts to affect the balance.
The balance displays the target weight value.
6 Place the displayed target weight on the pan and press
the PRINT key. The balance measures the target weight
and displays the measured value. Do not allow vibration
or drafts to affect the balance.
7 The balance displays
pan.
8 When the GLP output is set, the balance displays
and outputs "Calibration Test Report".
9 The balance will automatically return to the weighing
mode.
end . Remove the weight from the
34
From previous page
Target weight
glp1
GLP output