Table of Contents
Advertisement
OSD 79
OSD 80
OSD 81
TOOLS
6.5. SOFTWARE UPGRADE
There are two ways of upgrading the software of the receiver as
you can see at OSD 79.
6.5.1. RS232 UPGRADE
1. This function allows you to upgrade the software of the
receiver. This can be done from PC to receiver or from a master
receiver to a slave receiver.
2. Connect master receiver or PC to the slave receiver via serial
interface (0-Modem cable). Enter the "Software Upgrade"
menu of the master receiver and press [
upgrade mode. Upgrade modes include: allcode / maincode /
radioback / defaultdb / userdb (OSD 80).
3. Switch on the slave receiver.
4. Mark "Start" on the master reeciver and press [OK] to
start upgrade. Wait until the display on the front panel shows
"END". Then switch off the receiver and on again. Now the new
software is used.
7. Press [Exit] to save the setting without upgrade.
For more information about software upgrade, please visit
http://www.universbyfte.com
6.5.2. UPGRADE BY SATELLITE
This function can upgrade the software of your receiver through
data sent by a satellite. At the moment we offer satellite updates
only through ASTRA1 satellite.
1. Select the satellite and TP or input the TP value and
download PID.
2. Then mark "Start" and press [Enter] to begin the download
of the upgrade (OSD 81). This may need up to 60 Minutes.
Therefore we suggest using of this function only if you don't
intent to watch TV during this time.
At the moment of writing this manual, the data for the software
upgrade by Satellite is:
•Satellite: Astra
•TP Frequency: 12604 MHz.
•Symbol Rate: 22000
•Polarity: Horizontal
•Download PID: 1277
For changes in the data of the satellite please visit http://www.
universbyfte.com
6.6. SATCODX AUTO PROGRAMMING
This function is using the tables of the SatcoDX websites to
update your channel and satellite lists.
1. Start the SatcoDX application on your PC.
2. Select "SatcoDX Auto Programming" item from the "Tools"
menu and press [OK]. The screen will show the message "OK
to Proceed" (OSD 82).
PAG.
35
] to change the
Advertisement
Table of Contents
