Table of Contents
Advertisement
SYSTEM SETUP
5.6. LNB POWER
Here you can set the power output to the LNB (OSD 72). If
your receiver is connected to the LNB directly then you need to
set the LNB Power to "On". If your receiver is connected to a
multi switch (SMATV signal distribution system) then it may be
that you don't need to provide the power to the LNB. But since
this is depending on the kind of installed distribution system we
recommend you to contact your installer or to refer to the user
manual of this system to get the correct information.
You also just can change this setting and check if you still can
OSD 72
receive the channels. If the LNB Power is off and you still can
see all channels then we recommend this setting.
PAG.
32
Advertisement
Table of Contents
