Panel & Remote Control Description; Front Panel Description; Rear Panel Description - Univers by FTE U4109 User Manual

PANEL & REMOTE CONTROL DESCRIPTION
1. PANEL & REMOTE CONTROL DESCRIPTION

1.1. FRONT PANEL DESCRIPTION

1 2 3 4
1. POWER: Switches the receiver on, or enters standby mode. To completely switch off the receiver,
you have to use the switch on the back of the receiver.
2. POWER LED: Indicates that the mains voltage (90-230 VAC) is available.
3. LOCK LED: Indicates a suffi cient signal level at the IF IN input.
4. IR-SENSOR: Reception sensor for the IR remote control signals.

1.2. REAR PANEL DESCRIPTION

1 2 3
4 5 6
1. AC IN: Mains input cable.
2. IF IN: Satellite input.
3. RS-232: Serial Port allowing software upgrades.
4. IF OUT: Satellite output for cascading to other devices.
Note: The operation of another receiver at the same time is only possible with limited channel selection.
5. TV SCART: Output SCART for the connection to a TV set.
6. VCR SCART: Output SCART for the connection to a VCR.
PAG. 12