Remote Control Description; Basic Operations; Switch On Stb - Univers by FTE U4109 User Manual

1
4
19
12
10
16
13
20
2

2.0. SWITCH ON STB

Switch the [Device's Main Power] switch on.
When the STB is fi rst used it will display the quick setup page where the receiver can be confi gured
quickly.
For further use the STB will play the same channel as last time when it was switched off.
? FREQUENTLY ASKED QUESTION
Q: The power of my STB is on and it is running in TV mode but the TV screen shows nothing:
A: Make sure the TV set has been set to the correct video input (not the TV channels). For example, if
you have connected the STB to the Video1 input of the TV set, then you need to select the corresponding
Input on the TV. Mostly it is done with the AV button of the TVs remote control unit.
Q: My STB is running in TV mode but the TV screen shows nothing except one ball and "No Signal".
A: That means the channel you selected has no signal. This can be caused by several reasons:
1. The channel you selected is not from the satellite to which your dish is pointing. Select another
channel.
2. The signal of current TV channel is too weak. You can try to change to other channels with a stronger
signal. If the problems still exist, please consult your local dealer or installer for technical service.
3. You selected the wrong LNB type in the installation menu or your DiSEqC switch confi guration is
not correct.
PANEL & REMOTE CONTROL DESCRIPTION
7

2. BASIC OPERATIONS

PAG. 13
3
1.- Power
2.- Text
3.- Mute
4.- Numbers
5.- "0"
5
6.- CH+/CH-
18
7.- TV/R
8.- VOL+/VOL-
9.- Exit
10.- Menú
6
11.- Back
12.- OK
8
13.- EPG
9
14.- List
21
15.- Fav
14
16.- Audio
15
17.- Info
17
18.- Fav+/Fav-
11
19.- Pup/Pdw
20.- Zoom
21.- Sub