Table of Contents
Advertisement
OSD 46
OSD 47
OSD 48
OSD 49
INSTALLATION
functions to search the marked satellites and scan channels.
2. On "FTA Only" item, press [
channels or just scanning of free channels. If you select "Yes" it
will scan free channels only.
3. On "Scan Channel" item, press [
scanning range from TV + Radio Channels, only TV channels
or only Radio channels.
4. On "Scan Mode" item, you can select "Auto Scan" to make
a blind scan or "Preset Scan" to scan all preset transponders of
the selected satellites.
5. Select "Search" and press [OK] to start scanning. In the
lower part of the window the progress of scanning and the
found channels are displayed.
6. Press [Exit] to cancel or fi nish the scanning and saving the
found channels.
4.4. TP SCAN
When you enter "TP Scan" menu a window like the one beside
will be displayed (OSD 47).
1. On "Satellite" item, press [
you want to scan or press [OK] to open the satellite list for
selection.
2. On "TP Index" item use [
transponder. In this item you can also add, delete or delete all
TP.
- Press [Red] button to add a new TP (OSD 48). You have to
set the parameters of "TP Frequency" and "Symbol Rate" for
this new transponder. Therefore use the number buttons of
the RCU. The available range are "3000~13450 MHz" and
"1000~45000KS/s".
- Press [Green] button to delete the current TP. A safety ques-
tion will be displayed for confi rmation to delete the current
transponder or not (OSD 49). If you select "Yes", the current
transponder will be deleted and the total number of transpon-
ders will be reduced.
- Press [Yellow] button to delete all TP. A safety question will be
displayed for confi rmation to delete all transponders or not. If
you select "Yes", all transponders will be deleted.
3. For existing transponders you also can use number buttons
to modify the parameters of "TP Frequency" and "Symbol Rate"
or [
] to change the value directly. "Polarity" and "Scan
Mode" are used for setting scans conditions. Press [
select a different mode.
4. Polarity: Press [
5. On "FTA Only" item, press [
channels or just scanning of free channels. If you select "Yes" it
will scan free channels only.
6. After you completed your modifi cation select the "Search"
item and press [OK] to start scanning.
PAG.
25
] to select scanning of all
] to select the
] to select the satellite
] to select the desired
] to switch between "Auto / H / V".
] to select scanning of all
] to
Advertisement
Table of Contents
