Integra DTR-70.3 Instruction Manual page 88

Music Server and Internet Radio
■
Can't access the server or Internet radio
Check the network connection between the AV
receiver and your router or switch.
Make sure that your modem and router are properly
connected, and make sure they are both turned on.
Make sure the server is up and running and
compatible with the AV receiver.
Check the "Network" settings.
■
Playback stops while listening to music files on
the server
Make sure your server is compatible with the AV
receiver.
If you download or copy large files on your
computer, playback may be interrupted. Try closing
any unused programs, use a more powerful
computer, or use a dedicated server.
If the server is serving large music files to several
networked devices simultaneously, the network may
become overloaded and playback may be
interrupted. Reduce the number of playback devices
on the network, upgrade your network, or use a
switch instead of a hub.
■
Can't connect to the AV receiver from a Web
browser
If you're using DHCP, your router may not always
allocate the same IP address to the AV receiver, so if
you find that you can't connect to a server or Internet
radio station, recheck the AV receiver's IP address
on the "Network" screen.
Check the "Network" settings.
USB Device Playback
■
Can't access the music files on a USB device
Make sure the USB device is plugged in properly.
The AV receiver supports USB devices that support
the USB mass storage device class. However,
playback may not be possible with some USB
devices even if they conform to the USB mass
storage device class.
USB memory devices with security functions cannot
be played.
En
88
Others
■
Standby power consumption
— In the following cases, the power consumption in
standby mode may reach up to a maximum of
45W (DTR-80.3 North American models)/ 50W
—
(DTR-80.3 Other models)/ 115W (DTR-70.3 All
models):
99,
– You are using the Universal Port jack.
101
– "Network Control" is set to "Enable" in the
65
"Network" setting.
– "HDMI Control(RIHD)" setting is set to "On".
(Depending on the TV status, the AV receiver
will enter standby mode as usual.)
– The "HDMI Through" setting is set to other than
99,
"Off".
101
—
■
The sound changes when I connect my
headphones
When a pair of headphones is connected, the
—
listening mode is set to Stereo, unless it's already set
to Stereo, Mono, or Direct.
■
The speaker distance cannot be set as required
In some cases, corrected values suitable for home
theater use may be set automatically.
■
How do I change the language of a multiplex
source
65
Use the "Multiplex" setting on the "Audio Adjust"
menu to select "Main" or "Sub".
■
The functions don't work
65
To use , you must make an
an analog audio connection (RCA) between the
component and AV receiver, even if they are
connected digitally.
While Zone 2, Zone 3, or Zone 4 is selected, the
functions don't work.
—
—
■
The functions System Off/Auto Power On and
Direct Change don't work for components
connected via
While Zone 2, Zone 3, or Zone 4 is selected, the
—
functions don't work.
■
When performing "Automatic Speaker Setup",
the measurement fails and the message
"Ambient noise is too high." is displayed.
This can be caused by a malfunction in your speaker
unit. Check if the unit produces normal sounds.
18, 64,
65
—
—
53
20
connection and
20
20
—