Controlling Zone 2/3/4 Components - Integra DTR-70.3 Instruction Manual

Controlling Zone 2/3/4 Components

■
Operating on the AV receiver
Zone 2, Off Tone
Zone 3, Off –/+
Zone Level /
Zone 4, Off
1
To turn on Zone 2/3/4 and select an input source,
press Zone 2, Zone 3, or Zone 4 followed by an
input selector button within 8 seconds.
Zone 2/3/4 turns on, the Z2/Z3/Z4 indicator lights on
the display.
Tip
• The corresponding trigger output goes high (+12 V).
To select AM or FM, press Tuner input selector and
Zone 2, Zone 3, or Zone 4 repeatedly.
To select the same source as the main room's, press
Zone 2, Zone 3, or Zone 4 twice. "Z2 Selector:
Source", "Zone 3 Selector: Source", or "Zone 4
Selector: Source" appears on the display.
2
To turn off Zone 2/3/4, press Off for each Zone.
The zone is turned off, and the Z2/Z3/Z4 indicator
goes off.
Tip
• The corresponding trigger output goes low (0 volts).
■
Operating on the remote controller
To control Zone 2/3/4, you must press the remote
controller's Zone first.
Zone turns red while Zone 2 is on, and green while
Zone 3 is on, and amber while Zone 4 is on.
En
72
Input selector buttons
Receiver
Zone
Input selector buttons
Muting
VOL /
1
Press Zone repeatedly, then point the remote
controller at the AV receiver and press Receiver.
Zone 2/3/4 turns on, the Z2/Z3/Z4 indicator lights on
the display.
Tip
• The corresponding trigger output goes high (+12 V).
2
To select an input source for Zone 2/3/4, press
Zone repeatedly, followed by Input Selector.
To select AM or FM, press the Tuner input selector
and Zone repeatedly.
Note
• You cannot select different AM or FM radio stations for
your main room and Zone 2/3/4. The same AM/FM radio
station will be heard in each room.
3
To turn off Zone 2/3/4, press Zone repeatedly,
followed by Receiver.
Tip
• The corresponding trigger output goes low (0 volts).
Adjusting the Volume for Zones
■
Operating on the remote controller
1
Press Zone repeatedly.
2
Use VOL / to adjust the volume.
■
Operating on the AV receiver
1
Press Zone 2, Zone 3, or Zone 4 (the Z2/Z3/Z4
indicator on the display flash).
2
Use Zone Level / within 8 seconds to adjust the
volume.
If your Zone 2/3 speakers are connected to a receiver or
integrated amp in Zone 2/3, use its volume control to
adjust the volume.
Tip
• The Zone 2/3 volume, tone, and balance functions have no effect
on ZONE 2/3 PRE/LINE OUT when the "Zone 2 Out" or
"Zone 3 Out" setting is set to "Fixed"
Muting Zones
■
Operating on the remote controller
1
Press Zone repeatedly, and then press Muting.
Tip
• To unmute, press Zone followed by Muting again. Zones can
also be unmuted by adjusting the volume.
(➔ page 63).