Using Headphones; Using Easy Macros - Integra DTR-70.3 Instruction Manual

Using Headphones

1 Connect a pair of stereo headphones with a
standard plug (1/4 inch or 6.3 mm) to the Phones
jack.
While the headphones plug is inserted in the Phones
jack, indicator, speaker/channel indicator FL and
FR lights.
Note
• Always turn down the volume before connecting your
headphones.
• While the headphones plug is inserted in the Phones jack,
the speakers are turned off. (The Powered Zone 2/3/4
speakers are not turned off.)
• When you connect a pair of headphones, the listening mode
is set to Stereo, unless it's already set to Stereo, Mono, or
Direct.
• If you connect an iPod or iPhone to the USB port on the
AV receiver, no sound will be output from the headphones
jack.

Using Easy Macros

By using Activities in Easy macro mode, you can
sequentially operate Integra/Onkyo components via
simple commands from a single-button press. These
commands are user-definable. See "Using Normal
page 83).
Macros" (➔
1
Press Activities (My Movie, My TV, or
My Music) to start the Easy macro command.
The default sequences of actions are described below.
To change the related source component, see
"Changing the Source Components" shown later in
this chapter.
■
My Movie
First, the TV, the Integra/Onkyo Blu-ray Disc player, and
the AV receiver are turned on. The input selector is set to
"BD/DVD". Finally the player starts playback.
*1
Depending on the start-up time of your Blu-ray Disc/DVD
player, the AV receiver may not activate this playback
command. In this case, press
■
My TV
First, the TV, the cable set-top box, and the AV receiver
are turned on. Then the input selector is set to
"CBL/SAT".
■
My Music
The Integra/Onkyo CD player and the AV receiver are
turned on. The input selector is set to "TV/CD". Finally,
the player starts playback.
Note
• While the Easy Macro command is being processed, you cannot
use other Activities. If you want to operate other components,
first press All Off and use the desired Activities.
*1
on the remote controller.
Turning Off the Components
This button turns off all components activated by the Easy
Macro mode.
1
Press All Off.
First, the related components stop and turn off. Second,
the AV receiver turns off. Finally, the TV turns off (or
enters standby mode).
*1*2
*1 This step doesn't apply to My Music, with the default
settings.
*2
With some televisions, the power may not be turned off (or
enter standby mode).
Changing the Source Components
You can change the source components activated by the
Easy Macro mode.
1
While holding down Remote Mode for the
playback component you wish to assign, press and
hold down the Activities to be changed
(My Movie, My TV, or My Music) (about 3
seconds).
Activities flashes twice, indicating that the change is
complete.
Examples:
If you wished to use My Movie to start the playback
component assigned to VCR/DVR of Remote Mode,
you would press and hold down My Movie for about 3
seconds while pressing down VCR/DVR of Remote
Mode.
Restoring Default
You can restore Activities to the default settings.
1
While holding down Home, press and hold down
All Off until All Off lights (about 3 seconds).
2 Release Home and All Off, and press All Off
again.
All Off flashes twice.
En
43