Input/Output Assign; Monitor Out - Integra DTR-70.3 Instruction Manual

Input/Output Assign

Main Menu

Monitor Out

On the "Monitor Out" settings, you can select whether or
not to have the video sources' images output through the
HDMI output.
If you connect your TV to HDMI output, "Monitor Out"
setting is automatically set and composite video, S-Video,
and component video sources are upconverted
output.
Composite video, S-Video,
component video
Composite video, S-Video,
component video
If you connect your TV to the COMPONENT VIDEO
MONITOR OUT (not the HDMI output), "Monitor Out"
setting is automatically set and composite video and
S-Video sources are upconverted
Composite video, S-Video
Composite video, S-Video
Note
• See "Video Connection Formats"
showing how the "Monitor Out" and "Resolution" settings
affect the video signal flow through the AV receiver.
■
Monitor Out
Analog:
Select this if your TV is connected to the
COMPONENT VIDEO MONITOR OUT,
MONITOR OUT S, or MONITOR OUT V.
HDMI Main:
Select this if your TV is connected to HDMI OUT
MAIN.
HDMI Sub:
Select this if your TV is connected to HDMI OUT
SUB.
Both:
Select this if your TVs are connected to HDMI OUT
MAIN and HDMI OUT SUB. Video signals are
output from both HDMI outputs at the resolution
supported by both TVs.
En
46
Input/Output Assign
* and
HDMI
IN
OUT
HDMI
*
and output.
Component video
IN
OUT
Component video
page 93) for charts
(➔
Both(Main):
Select this if your TVs are connected to HDMI OUT
MAIN and HDMI OUT SUB. Video signals are
output from both HDMI outputs but HDMI OUT
MAIN will become a priority; depending on the
resolution, video signals may not be output from
HDMI OUT SUB.
Both(Sub):
Select this if your TVs are connected to HDMI OUT
MAIN and HDMI OUT SUB. Video signals are
output from both HDMI outputs but HDMI OUT
SUB will become a priority; depending on the
resolution, video signals may not be output from
HDMI OUT MAIN.
Note
• If not connected to the same output you have selected in the
"Monitor Out" setting, the "Monitor Out" setting will be
automatically switched to "Analog".
• When using the DeepColor function, if the "Monitor Out"
setting is set to "Both(Main)" or "Both(Sub)", the number of
bits may be limited due to the capability of your TV connected
to a priority output.
Changing the "Monitor Out" setting manually
1
Press Monitor Out on the front panel.
The current setting is displayed.
2
Press Monitor Out repeatedly to select:
Analog, HDMI Main, HDMI Sub, Both,
Both(Main) or Both(Sub)
■
Resolution
Through :
*1
Select this to pass video through the AV receiver at
the same resolution and with no conversion.
Auto :
*2
Select this to have the AV receiver automatically
convert video at resolutions supported by your TV.
480p (480p/576p), 720p, 1080i, 1080p
Select the desired output resolution.
1080p/24 :
*2*3
Select this for 1080p output at 24 frames per second.
4K Upscaling :
*2*3
Select this for an output resolution four times that of
1080p, resulting in 3840 × 2160 pixels.
Source:
Output will be according to the resolution level
which was set in the "Picture Adjust"
You can specify the output resolution for the HDMI
output(s) and COMPONENT VIDEO MONITOR OUT
so that the AV receiver upconverts the picture resolution
as necessary to match the resolution supported by your
TV.
:
*2
(➔ page 58).