Using Zone 2/3/4 - Integra DTR-70.2 Instruction Manual

■
Zone 2 Power On Volume,
Zone 3 Power On Volume,
Zone 4 Power On Volume
Last, Min, 1 to 99 or Max (Absolute display)
Last, – dB, –81dB to +18dB (Relative display)
This setting determines what the volume will be for
Zone 2/3/4 each time the AV receiver is turned on.
To use the same volume level as when the AV receiver was
last turned off, select "Last".
The "Zone 2 Power On Volume", "Zone 3 Power On
Volume" and "Zone 4 Power On Volume" cannot be set
higher than the "Zone 2 Maximum Volume", "Zone 3
Maximum Volume" and "Zone 4 Maximum Volume"
setting.
■
Zone 2 Component Out
Use:
Select if a TV in Zone 2 is connected the COMPO-
NENT VIDEO ZONE 2 OUT.
Not Use:
Select if no TV in Zone 2 is connected the COMPO-
NENT VIDEO ZONE 2 OUT.
If you've connected the COMPONENT VIDEO ZONE 2
OUT to a TV in Zone 2, this setting is set to "Use".
Note
If the "Zone 2 Component Out" setting is set to "Not
Use", the same video signal as COMPONENT VIDEO
MONITOR OUT is output from ZONE 2 OUT (compo-
nent).

Using Zone 2/3/4

This section explains how to turn Zone 2/3/4 on and off,
how to select an input source for Zone 2/3/4, and how to
adjust the volume for Zone 2/3/4.
Controlling Zone 2/3/4 from the AV receiver
Zone 4 indicator
Zone 3 indicator
Zone 2 indicator
Input selector buttons
Zone 4 Off
Zone 3
Zone 2
1
To turn on Zone 2/3/4 and select an input source,
press Zone 2, Zone 3 or Zone 4 followed by an
input selector button within 8 seconds.
Zone 2/3/4 turns on, the Zone 2/3/4 indicator lights.
Tip
• The 12V TRIGGER OUT goes high (+12 V).
To select AM or FM, press Tuner input selector and
Zone 2, Zone 3 or Zone 4 repeatedly.
(North American models) You can also select SIR-
IUS.
To select the same source as that of the main room,
press Zone 2, Zone 3 or Zone 4 twice. "Zone2
Selector: Source", "Zone3 Selector: Source" or
"Zone4 Selector: Source" appears on the display.
2
To turn off Zone 2/3/4, press Off for each Zone.
The zone is turned off, and the Zone 2, Zone 3 or
Zone 4 indicator goes off.
Note
• When Zone 2/3/4 is turned off, the output from the 12V TRIG-
GER OUT goes low (0 volts).
En
87