Replacing The Fuse - Yamaha JOGR JOGRR CS50 Owner's Manual

To store the battery
1. If the model will not be used for
more than one month, remove
the battery, fully charge it, and
then place it in a cool, dry place.
2. If the battery will be stored for
more than two months, check it
at least once a month and fully
charge it if necessary.
3. Fully charge the battery before
installation.
4. After installation, make sure that
the battery leads are properly con-
nected to the battery terminals.
CAUTION:
● Always keep the battery char-
ged. Storing a discharged bat-
tery can cause permanent bat-
tery damage.
●
To charge a sealed-type (MF)
battery, a special (constant-
voltage) battery charger is
required. Using a conventional
battery charger will damage
the battery. If you do not have
access to a sealed-type (MF)
battery charger, have a Yamaha
dealer charge your battery.
PERIODIC MAINTENANCE AND MINOR REPAIR

Replacing the fuse

The fuse holder is located beside the
battery case.
If the fuse is blown, replace it as
follows.
1. Turn the key to "e" and turn off
all electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage.
ECA10630
1. Main fuse
Specified fuse:
7.5 A
EAUS1180
CAUTION:
Do not use a fuse of a higher ampe-
rage rating than recommended to
avoid causing extensive damage to
the electrical system and possibly a
fire.
3. Turn the key to "f" and turn on
4. If the fuse immediately blows
6-20
the electrical circuits to check if
the devices operate.
again, have a Yamaha dealer
check the electrical system.
ECA10640
6