Replacing The Headlight Bulb Or A Front Turn Signal Light Bulb - Yamaha JOGR JOGRR CS50 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
Replacing the headlight bulb
or a front turn signal light
bulb
If a bulb burns out, replace it as
follows.
CAUTION:
It is advisable to have a Yamaha
dealer perform this job.
Headlight bulb
1. Remove cowling A.
2. Disconnect the headlight leads,
and then unhook the headlight
6 bulb holder as shown.
1
B Y G
1. Headlight couplers
2. Headlight bulb holder
EAUS1430 3. Remove the bulb holder by
pulling it and then, remove the
defective bulb by turning it coun-
terclockwise.
ECA10670
4
1. Bulb holder
2. Push in and turn counterclockwise.
3. Remove the bulb.
4. Headlight bulb
s WARNING
s
2
Headlight bulbs get very hot. The-
refore, keep flammable products
away from a lit headlight bulb, and
do not touch the bulb until it has
cooled down.
4. Insert a new headlight bulb into
2
1
3
5. Place the bulb holder in its origi-
6. Connect the headlight leads and
EWA10790
7. Have a Yamaha dealer adjust the
6-21
the bulb holder and turn it clock-
wise.
B B Y Y G G
nal position, and then secure it
with its holder as shown.
install the cowling.
headlight beam if necessary.