Starting Off - Yamaha EC-03 Owner's Manual

TIP
When the vehicle enters the riding
mode, the beeper sounds. The beeper
stops sounding when either brake lever
is squeezed or the vehicle starts mov-
ing.
If the entered security number is
incorrect, the buzzer sounds, "NG"
flashes for a few seconds, and the
vehicle returns to the standby
mode.
1
1. Incorrect number indicator "NG"
If this occurs, repeat the procedure
from the step 6.
TIP
If an incorrect security number is en-
tered three times in succession, the se-
OPERATION AND IMPORTANT RIDING POINTS
curity lock cannot be unlocked even if
the correct security number is entered.
Repeat the procedure after first turning
the key to "OFF" and then back to "ON"
again.
8. Check the battery level indicator to
make sure that the remaining
charged level is sufficient. (See
page 3-4 for more information
about the charge level.)
1
1. Battery level indicator
7-3

Starting off

1. Check that the operating status in-
dicator "RUN" is displayed, and
that the vehicle is in the riding
mode.
1
1. Operating status indicator "RUN"
2. Power mode indicator "POWER"
TIP
If the vehicle is set to the power mode,
the power mode indicator "POWER" is
displayed. (See page 3-1 for more in-
formation about switching the display
between the standard mode and the
power mode.)
2. Switch the turn signal on.
EAU50103
2
2
3
4
5
6
7
8
9