Table of Contents
Advertisement
OPERATION AND IMPORTANT RIDING POINTS
OPERATION AND IMPORTANT RIDING POINTS
Read the Owner's Manual carefully
to become familiar with all controls.
If there is a control or function you
do not understand, ask your Yamaha
1
dealer.
2
WARNING
Failure to familiarize yourself with
the controls can lead to loss of con-
3
trol, which could cause an accident
or injury.
4
TIP
5
This model is equipped with a lean
angle sensor to stop the engine in
6
case of a turnover. To start the en-
gine after a turnover, be sure to turn
7
the main switch to "OFF" and then to
"ON". Failing to do so will prevent the
engine from starting even though the
8
engine will crank when pushing the
start switch.
9
EAU15951
Starting a cold engine
NOTICE
See page 5-3 for engine break-in
instructions prior to operating the
EWA10271
vehicle for the fi rst time.
1. Turn the key to "ON" and make
sure that the engine stop switch
is set to "#".
2. Close the throttle completely.
3. Start the engine by pushing the
EAU45310
start switch while applying the
front or rear brake. NOTICE: For
maximum engine life, never ac-
celerate hard when the engine
is cold!
[ECA11041]
If the engine does not start, re-
lease the start switch, wait a few
seconds, and then try again.
Each starting attempt should be
as short as possible to preserve
the battery. Do not crank the en-
gine more than 5 seconds on any
one attempt. If the engine does
not start with the starter motor, try
using the kickstarter.
EAUT2082
Starting off
ECA10250
TIP
Before starting off, allow the engine to
warm up.
1. While pulling the rear brake lever
2. Sit astride the seat, and then ad-
3. Switch the turn signals on.
4. Check for oncoming traffi c, and
5. Switch the turn signals off.
5-1
with your left hand and holding
the grab bar with your right hand,
push the scooter off the center-
stand.
just the rear view mirrors.
then slowly turn the throttle grip
(on the right) in order to take off.
EAU15943
EAU15943
EAU16761
Advertisement
Table of Contents
Troubleshooting
