Operation And Important Riding Points; Starting A Cold Engine - Yamaha Zuma YW50FE 2014 Owner's Manual

OPERATION AND IMPORTANT RIDING POINTS

OPERATION AND IMPORTANT RIDING POINTS
Read the Owner's Manual carefully
to become familiar with all controls.
If there is a control or function you
do not understand, ask your Yamaha
1
dealer.
2
WARNING
Failure to familiarize yourself with
the controls can lead to loss of con-
3
trol, which could cause an accident
or injury.
4
TIP
5
This model is equipped with a lean
angle sensor to stop the engine in
6
case of a turnover. To start the en-
gine after a turnover, be sure to turn
7
the main switch to "OFF" and then to
"ON". Failing to do so will prevent the
engine from starting even though the
8
engine will crank when pushing the
start switch.
9
EAU15951

Starting a cold engine

NOTICE
See page 5-3 for engine break-in
instructions prior to operating the
EWA10271
vehicle for the fi rst time.
1. Turn the key to "ON" and make
sure that the engine stop switch is
set to " ".
2. Close the throttle completely.
3. Start the engine by pushing the
EAU45310
start switch while applying the
front or rear brake.
If the engine does not start, re-
lease the start switch, wait a few
seconds, and then try again.
Each starting attempt should be
as short as possible to preserve
the battery. Do not crank the en-
gine more than 10 seconds on
any one attempt. If the engine
does not start, try with the throttle
open 1/8 turn.
NOTICE
For maximum engine life, never ac-
celerate hard when the engine is
EAUT1513
cold!
ECA10250
ECA11042
5-1
EAU15943 EAU15943