Operation And Important Riding Points; Starting The Engine - Yamaha NEO'S 4 2008 Owner's Manual

OPERATION AND IMPORTANT RIDING POINTS

Read the Owner's Manual carefully to
become familiar with all controls. If
there is a control or function you do
not understand, ask your Yamaha
dealer.
s WARNING
s
Failure to familiarize yourself with
the controls can lead to loss of
control, which could cause an acci-
dent or injury.
5
TIP
This model is equipped with a lean
angle sensor to stop the engine in
case of a turnover. To start the engine
after a turnover, be sure to turn the
main switch to "OFF" and then to
"ON". Failing to do so will prevent the
engine from starting even though the
engine will crank when pushing the
start switch.
EAU15951

Starting the engine

NOTICE
See page 5-4 for engine break-in
instructions prior to operating the
EWA10271
vehicle for the first time.
EAU45310
1. Turn the key to "ON".
NOTICE
The engine trouble warning light
and coolant temperature warning
light should come on for a few
seconds, then go off. If these war-
ning lights do not go off, have a
Yamaha dealer check their electri-
cal circuits.
2. Close the throttle completely.
EAUT2251 3. Start the engine by pushing the
ECA10250
ECAT1070
5-1
start switch while applying the
front or rear brake. NOTICE: For
maximum engine life, never
accelerate hard when the engi-
ne is cold!
[ECA11041]
If the engine does not start, rele-
ase the start switch, wait a few
seconds, and then try again.
Each starting attempt should be
as short as possible to preserve
the battery. Do not crank the
engine more than 5 seconds on
any one attempt. If the engine
does not start with the starter
motor, try using the kickstarter.