Page 1
I N S T A L L A T I O N I N S T R U C T I O N S Small Flat Panel Tilt Wall Mount Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description FTR Series...
Reinforce the structure as required before installing the component. The wall to which the mount is being attached Chief® is a registered trademark of Milestone AV Technologies. may have a maximum drywall thickness of 5/8" (1.6cm). Do All rights reserved.
Installation Instructions FTR Series LEGEND Tighten Fastener Pencil Mark Apretar elemento de fijación Marcar con lápiz Befestigungsteil festziehen Stiftmarkierung Apertar fixador Marcar com lápis Serrare il fissaggio Segno a matita Bevestiging vastdraaien Potloodmerkteken Serrez les fixations Marquage au crayon Loosen Fastener Drill Hole Aflojar elemento de fijación...
Page 4
FTR Series Installation Instructions INSTALLATION Level FTR assembly (A) at desired height and, using it as a template, mark the location of the four anchor holes (one in each corner slot). The FTR may be installed on either a single 2" x 4" wood stud, or on drywall (1/2"...
Page 5
Installation Instructions FTR Series Repeat Steps 4 and 5 for remaining anchors. Lift and maneuver display such that all mounting buttons fit into openings on FTR (A). (See Figure 6) Remove and retain anchor screws from anchors (B). Lower display firmly into place. Ensure each mounting...
FTR Series Installation Instructions NOTE: An optional padlock may be used to secure latching flag in place. (See Figure 8) 5° Tilt Up 15° Tilt Down Figure 9 NOTE: Display not shown for clarity. Figure 8 Connect cables to display as required.
Page 8
Europe A Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands P +31 (0)40 2668620 F +31 (0)40 2668615 Chief Manufacturing, a products division Asia Pacific A Office No. 1 on 12/F, Shatin Galleria of Milestone AV Technologies 18-24 Shan Mei Street...
Need help?
Do you have a question about the FTR Series and is the answer not in the manual?
Questions and answers