Installing The Software From The [Scansnap Setup] Dialog Box - Fujitsu ScanSnap SV600 Basic Operation Manual

Installing the Software from the [ScanSnap Setup] Dialog Box

Once the software is uninstalled or the installation information is removed, install the software from
the [ScanSnap Setup] dialog box.
Install the software in the following procedure.
1.
Restart the computer.
2.
Log on as a user with Administrator privileges.
3.
If anti-virus software is running, disable the software temporarily.
ATTENTION
If you cannot disable the anti-virus software, check if the software is set to lock the application.
4.
Install the software.
For details, refer to
If you did not perform the procedure in
the software, perform the following procedures again:
l "Uninstalling the Software" (page 106)
l "Removing the Installation Information" (page 107)
l "Installing the Software from the [ScanSnap Setup] Dialog Box" (page 112)
If you still could not reinstall the software after performing the above procedures, proceed to
Software at a Time" (page
"Standard Installation" (page
"Removing the Installation Information" (page 107)
113).
If You Have Installed the Software Before
133).
112
and then failed to install
"Installing One