Fujitsu ScanSnap SV600 Basic Operation Manual page 66

Also, you can change the setting so that the scanned image of the spine of the book can be
imported immediately after the scanned images of the covers and pages of the book are
imported.
For details, refer to the Rack2-Filer Smart Help.
ATTENTION
When you scan the spine of a book, place the book as shown in the following figure:
On the [ScanSnap Manager - Image scanning and file saving] window, which appears after
scanning, select [Crop and save flat document images as-is], and then click the [Save this
image] button.
Correcting scanned images
is displayed on each of the pages scanned from the book. Work data used for
correcting scanned images is attached to each page on which
You can correct distorted scanned images in Book Image Viewer, which is displayed by
double-clicking
For details, refer to the Book Image Viewer Help, which appears when the Help button (
is clicked.
ATTENTION
Work data is stored in the hard disk. It is recommended that you delete work data if there is no
problem with the corrected image.
For details, refer to the Rack2-Filer Smart Help.
.
66
Reproducing a Book in Rack2-Filer Smart
is displayed.
)