Using The Mouse; Status Leds - GE 30 User Manual

Chapter 3: Operating instructions
Item Name
6 Archive button
7

Status LEDs

8 Function buttons
9 Playback controls
Status LEDs
The LEDs on the front panel of the DVR are described as follows.
Table 3: Status LED descriptions
LED Name
Power
Network
Alarm
REC
Record

Using the mouse

Use the USB mouse provided with the TVR 30 to carry out the same operations as the
front panel and remote control. Connect the mouse to the TVR 30 by plugging the
mouse USB connector into one of the USB ports on the front panel. The mouse is
immediately operational and the pointer should appear.
Click the left mouse button to enter or confirm a selection. This is similar to pressing
Enter button on the front panel. Click the right mouse button to the exit setup menus
and save the settings. Use the scroll wheel to change values.
12
Description
Begin archiving or displays the Archive screen.
Press once to begin copying a video segment for export
while in playback mode. Press again to stop copying. See
"Archiving recorded files" on page 34 for more information.
Display device status and conditions. See "Status LEDs"
below for more information.
Change the TVR 30 operating mode. For example, press
PTZ to go into PTZ mode. See "Operating modes" on page
17 for more information.
Control video playback speed.
Description
Steady indicates that the correct power is connected to the unit.
Blinking indicates that the DVR is connected to a network.
Steady indicates that an alarm is triggered.
Blinking indicates that the TVR 30 is recording. Steady indicates hard
drive failure.
TruVision DVR 30 User Manual