Enabling And Disabling End User Settings - Symantec 10490452 - Mail Security 8220 Administration Manual

Enabling and disabling end user settings

The end user settings determine whether end users in a group can log in to the
Control Center to configure personal Allowed and Blocked Senders Lists and
block or allow email in specified languages.
Note: Depending on your system and the group you are editing, you may not be
able to view the End Users tab on the Edit Group page. See
enabling end user settings"
To log in, users access the same URL in their browser as Control Center
administrators: https://<hostname>:41443/brightmail. The login and password
for end users is the same as their LDAP login and password. For information
about supported browsers, see the Symantec Mail Security for SMTP Installation
Guide.
Note: End users are limited to a total of 200 entries in their combined Allowed
Senders and Blocked Senders Lists.
The Specify language settings check box enables or disables user access to the
language identification offered by Symantec Mail Security for SMTP, not the
Symantec Outlook Spam Plug-in. If the Symantec Outlook Spam Plug-in is
installed and enabled, end users can set their language preferences using the
Options dialog box accessible from the Symantec Outlook Spam Plug-in toolbar.
Note: The language identification technology employed by Symantec Mail
Security for SMTP to identify the language of a message is not foolproof. Note
that messages identified to be in a disallowed language are deleted.
Requirements for enabling end user settings
The following requirements must be satisfied before end users can configure
their own personal Allowed and Blocked Senders Lists and block or allow email
in specified languages:
At least one LDAP SyncService server must be configured and enabled.
■
In Settings > LDAP settings, an LDAP source configured for Authentication
■
or Authentication and Synchronization must be defined and saved.
In Settings > Replication settings, a replication schedule must be defined
■
and enabled.
on page 79 for details.
Configuring email filtering
Assigning filter policies to a group
"Requirements for
79