Charging The Battery; Recycling Your Batteries; Attaching Belt Loop System - Printek Mt3 Series Operator's Manual

Charging the Battery

Insert the AC adaptor plug into the printer. The Yellow/Amber charging LED
will illuminate indicating that the battery is being charged.
After about 90 minutes the LED will go off and the battery will be fast charged.
Note: You must charge the battery for 24 hours prior to the first use.
Maximum battery capacity is reached after completing a minimum of
(3) normal usage charge and discharge cycles.

Recycling your Batteries

The Rechargeable Battery Recycling Corporation (RBRC) is a non-profit
organization created to promote recycling of rechargeable batteries. For more
information about how to recycle batteries in your area, visit www.rbrc.org.

Attaching Belt Loop System

To attach the belt loop system, insert the round knob located at the bottom of
the printer into the latch mechanism. When installed completely, you will hear
it click into place. To remove, squeeze the opposing 'ears' and slide clear of
the knob.
6