Battery And Safety Information - Printek Mt3 Series Operator's Manual

Battery and Safety Information

!
A 6.0 volt 1600mAH NiMH battery cartridge powers the printer.
Note: Battery capacity is always improving so there is a
the capacity may be higher than this. Please check with Printek.
!
Charging time in the printer is approximately 90 minutes.
!
Take the battery out of the printer when storing the printer for long
periods of time.
!
The battery storage temperature is 40 degrees F to 104 degrees F (4C
to 40C). Do not store a fully charged battery at temperatures greater
than 104 degrees F (40C) for long periods of time – the battery may
permanently lose charge capacity.
!
Be sure to use a fully charged battery before long or battery intensive
printing sessions. Certain operations (for example, printing receipts
with a lot of bar codes and graphics) drain the battery more quickly
than others. Disposal information – do not throw in trash. Dispose
according to your local regulations.
Caution:
Do not disassemble, short circuit, heat above 80C, or incinerate.
The battery may explode.
!
The recommended room temperature for charging is between 68
degrees F (20C) to 77 degrees F (25C).
possibility that
4