Call & Message; Calling - Pantech Burst User Manual

English - manual
Hide thumbs Also See for Burst:
Table of Contents

Advertisement

3. Call & Message

Calling

Making a call
1. Tap Phone from the launcher.
2. Enter an area code and a phone
number.
3. Tap
.
Note Tap
to delete. Tap and hold
delete the whole number.
Answering and ending a call
1. Drag
to the right to answer a call.
2. Tap
to end a call during
conversation. After ending a call, its
summary is shortly displayed.
Rejecting a call
1. Drag
into the circle to reject a call.
Note You can also send a message before rejecting a call by
dragging
into the circle.
to
Phone main display
Incoming call
Adjusting the volume
1. Press the upper volume key to increase the volume during a
call.
2. Press the lower volume key to decrease the volume during a
call.
Note
Press the volume key in idle mode if you want to adjust the ringtone
volume. If you want to set it to the vibrate mode, press the volume
key all the way down until the mode appears.
You can disable or enable the noise suppression function during
a call. Tap > Noise suppression. Tap On or Off to turn on or off
the speaker. For more information about the noise suppression
function, refer to "Setting Noise Suppression" on page 77.
Holding and unholding a call
1. Tap
during a call. The party will hear nothing.
2. Tap
to resume the call.
3. Tap
to finish the call.
Swapping a call for a multiparty call
1. The first party will hear a waiting sound.
2. Tap
to change the calling party.
3. Tap
to finish the call.
Making a conference call
1. Tap Phone from the launcher.
2. Enter an area code and a phone number.
3. Tap Add call to invite a third party to the call.
4. Tab Merge calls to make conference.
30

Advertisement

Table of Contents
loading

Table of Contents