Getting Started; Inside The Package; Sim/Usim Card And Battery - Pantech Burst User Manual

English - manual
Hide thumbs Also See for Burst:
Table of Contents

Advertisement

1. Getting Started

Follow the outlined steps that should be taken first before
using Burst.

Inside the package

The package should contain the following items:
Handset
Battery
USB/Wall Charger
Quick Start Guide

SIM/USIM card and battery

About the SIM/USIM card
When you subscribe to the network operator, you receive
the Subscriber Identity Module (SIM) card or the Universal
Subscriber Identity Module (USIM) card that contains your
registration information, PIN code, etc. You should keep it
secure and handle it carefully. Do not bend, scratch or expose
it to moisture. Avoid static electricity.
About the battery
This phone uses a lithium-ion (Li-Ion) battery. Make sure to
use the authorized battery and charger only. Maximum time to
use the battery might vary depending on the temperature and
service types offered by the service provider. For more details,
contact your nearest dealer.
Note The Li-Ion battery can be recharged while some charge
remains without reducing its effectiveness as a result of the "memory
effect" inherent in other battery technologies.
Installing the SIM/USIM card and battery
1. Remove the battery cover from the unit.
To remove the battery cover, place
your fingernail in the groove at the
bottom of the unit, and then lift it up.
2. Insert the SIM/USIM card into the slot.
Ensure that the gold contacts of the
card go against the metal contacts of
the phone.
3. Slide the connector of the battery into
the notch located at the top of the
unit. Insert and press the lower side of
the battery until you hear a click. Make
sure you align the gold contacts on the
battery end with the contacts on the
phone. If the contacts on the battery
are not properly aligned, the phone
and the battery could be damaged.
4. To remove the battery, lift the bottom
of the battery up and remove. To
remove the SIM card, slide the SIM
card in the direction of the arrow as
shown.
5. To place the battery cover back onto
the unit, slide the one end of the cover
into the groove, and then push it
down.
9

Advertisement

Table of Contents
loading

Table of Contents