Incorporation Into 19" Flightcases Or 19" Rack Systems; Fuses - Dynacord DPA 4410 Owner's Manual

T101
INPUT 1
T102
INPUT 2
TO AMP_A
PCB 84167
Diagram 9
10.

INCORPORATION INTO 19" FLIGHTCASES OR 19" RACK SYSTEMS

Note Do not operate the DPA 4410 without its enclosure or without parts of the enclosure.
When incorporating the DPA 4410 into a 19" flightcase or 19" rack system make sure, that there is sufficient
air-flow. Between the amplifier's rear plate and the back-wall of the surrounding enclosure there has to
be at least a space of 60 mm x 330 mm up to the enclosures ventilation gaps. Above the rack system
should be at least a space of 100 mm for a sufficient circulation of the air. During the operation of the DPA
4410 the environmental temperature within the rack closet may increase by about 10° C. This has to be
taken into consideration when installing other equipment into the same rack system or other enclosures.
Note For trouble-free operation of the appliance, the maximum environmental temperature should
not exceed +40° C.
11.

FUSES

location
fuse switch (11)
fuse switch (11)
PCB 85264.2
PCB 85264.2
PCB 85264.2
PCB 85264.2
PCB 85264.2
PCB 85264.2
TO REMOTE CONTROL
PCB 81330.2
Printed circuit board 81330.1 with inserted input transformers NRS90208
pos. used for
F501 mains fuse 230V~ AC
F501 mains fuse 115V~ AC
F502 battery fuse 24V DC
F503 battery fuse 24V DC
F504 power-AMP 1
F505 power-AMP 2
F506 power-AMP 3
F507 power-AMP 4
value dimensions
T4A 250V 5 x 20 mm
T8A 250V 5 x 20 mm
25A 32V flat-type fuse
25A 32V flat-type fuse
T6.3A 250V 5 x 20 mm
T6.3A 250V 5 x 20 mm
T6.3A 250V 5 x 20 mm
T6.3A 250V 5 x 20 mm
28
T104
INPUT 4
T103
INPUT 3
TO AMP_B
PCB 84167
standard
IEC 127
IEC 127
DIN 72581-3
DIN 72581-3
IEC 127
IEC 127
IEC 127
IEC 127