Use Open (No Security) Associations With Funk Security - Intermec CN51 User Manual

CN51 Mobile Computer User Manual
3 Select a Funk security profile to configure.
4 Enter the SSID.
5 For Association, select Open.
6 For Encryption, select WEP.
7 For 8021x, select None.
8 Enter an ASCII key or hex key value for each key you want to use
(Key 1 through Key 4):
• For 64-bit WEP, enter a 5-byte value: 5 ASCII characters or 0x
followed by 5 hexadecimal pairs.
• For 128-bit WEP, enter a 13-byte value: 13 ASCII characters or
0x followed by 13 hexadecimal pairs.
9 Select the Transmit key you want to use to transmit data.
10 Tap OK.
Use Open (No Security) Associations with Funk
Security
To create an open network, you can set no security with Funk security.
1 Start Intermec Settings.
2 Select Communications > 802.11 Radio > Funk Security.
3 Select the active Funk security profile.
4 Enter the SSID.
5 For Association, select Open.
6 For Encryption, select WEP.
7 Tap OK.
Chapter 6 — Configure the Computer
99